Philips AVENT Vigilabebés DECT - Manual (Page 11)

lullaby function
1 Briefly press the lullaby button K on the baby unit to select one of the five lullabies
available. (Fig. )
 Briefly press the play/stop button E to play the selected lullaby. (Fig. )
 Briefly press the OK button on the parent unit to interrupt the lullaby. Press the OK button
on the parent unit again to continue the lullaby (Fig. 5).
If you do not continue the lullaby within 60 seconds, the lullaby function switches off
automatically.
 Briefly press the play/stop button E on the baby unit again to stop the lullaby. (Fig. )
Note: If you press the lullaby button K too long, no lullaby is selected.
Belt clip and neck strap
If the batteries of the parent unit are sufficiently charged, you can take the unit with you inside and
outside the house if you attach the unit to your belt or waistband with the belt clip or if you hang it
round your neck with the neck strap. This allows you to monitor your baby while you are moving
around.
Connecting the belt clip
1 Insert the small pin on the back of the belt clip into the opening on the back of the parent
unit (1). Turn the belt clip to the left () until it locks into position (‘click’) (Fig. 6).
Disconnecting the belt clip
1 Turn the belt clip to the right (1) and take it out of the opening () (Fig. 7).
Connecting the neck strap
1 Insert the small pin at the end of the neck strap into the opening on the back of the parent
unit (1). Turn the neck strap to the left () until it locks into position (‘click’) (Fig. 8).
Disconnecting the neck strap
1 Turn the neck strap to the right (1) and take it out of the opening () (Fig. 9).
reset function
This function allows you to reset the parent unit and baby unit to the default settings. You can use
this function if problems occur that cannot be solved by following the suggestions in chapter
‘Frequently asked questions’. You have to reset each unit separately.
1 Press and hold the on/off button 3 for  seconds to switch on the unit. (Fig. 11)
 Then immediately press and hold the volume down (-) button until the message ‘Reset’ is
shown on the display (Fig. 0).
The unit has now been reset to the default factory settings.
Now do the same for the other unit.
Default settings
Parent unit
Loudspeaker volume: 1
Microphone sensitivity: 3
Sound alert: on
Temperature alert: on
‘Temperature low’ alert: 14°C
‘Temperature high’ alert: 30°C
,
,
-
-
-
-
-
-
EngliSh 11