Philips AVENT Vigilabebés DECT - Manual (Page 13)

 Select the desired microphone sensitivity level for the baby unit by pressing the – and +
buttons and confirm by pressing the OK button.
one light on = minimum sensitivity level
all lights on = maximum sensitivity level
Note: When the microphone sensitivity of the baby unit is set to a high level, it picks up more sounds and
therefore transmits more often. As a result, the units consume more power.
Sound alert on/off
If the sound alert is switched on, the parent unit beeps as soon as the fifth sound level light lights up
blue while the volume is switched off.
1 Select X by pressing the – and + buttons and confirm by pressing the OK
button.
 Select C or V and confirm by pressing the OK button.
Setting room temperature range
You can set the temperature range (minimum and maximum temperature) for your baby’s room.
1 Select B– – ° by pressing the – and + buttons and confirm by pressing
the OK button.
N appears on the display.
 Confirm by pressing the OK button.
 Set the desired minimum temperature by pressing the – and + buttons and confirm by
pressing the OK button.
 Set the desired maximum temperature by pressing the – and + buttons and confirm by
pressing the OK button.
Note: When the maximum temperature selected is lower than the room temperature, the unit consumes
more power because the display is on continuously. This is also the case when the minimum temperature
set is higher than the room temperature.
temperature alert on/off
If the temperature alert is switched on, the parent unit beeps if the actual room temperature
exceeds the set maximum temperature or drops below the set minimum temperature. If no
minimum and maximum temperatures have been set, the temperature alert goes off when the
room temperature drops below 7°C or rises above 33°C.
1 Select B– – ° by pressing the – and + buttons and confirm by pressing
the OK button.
 Select M by pressing the – and + buttons and confirm by pressing the OK
button.
 Select C or V and confirm by pressing the OK button.
Cleaning and maintenance
Do not immerse the parent unit and the baby unit in water and do not clean them under the tap.
Do not use a cleaning spray and/or liquid cleaners.
1 Unplug the baby unit if it is connected to the mains and take the parent unit out of the
charger.
 Clean the parent unit and the baby unit with a damp cloth.
,
,
,
EngliSh 1