Temperature alert on/off, Reset function, Default settings – Philips AVENT Vigilabebés DECT User Manual

Page 14

Advertising
background image

8

Press the OK button to confirm.

, The message ‘Saved’ appears on the display.
Note: If the temperature in the baby’s room drops below or exceeds the set temperature range, the

display of the parent unit is on continuously. This causes the unit to consume more power.

temperature alert on/off

Note: You can only switch the temperature alert on and off in the menu of the parent unit.
Note: If the temperature alert is activated too often, reduce the set minimum temperature and/or

increase the set maximum temperature (see ‘Setting room temperature range’).

If the temperature alert is switched on, the parent unit beeps if the actual room temperature

exceeds the set maximum temperature or drops below the set minimum temperature. In addition,

the backlight of the parent unit display goes on and ‘High’ or ‘Low’ appears on the display. If no

minimum and maximum temperatures have been set, the temperature alert is given when the room

temperature drops below 14°C or rises above 30°C.

1

Select ‘Temperature’ with the + and - buttons.

2

Press the OK button to confirm.

3

Select ‘Alert’ with the + and - buttons.

4

Press the OK button to confirm.

5

If the alert is off, the display shows ‘On?’. Press the OK button to switch on the alert. If the

alert is on, the display shows ‘Off?’. Press the OK button to switch off the alert.
reset function

This function in the menu of the parent unit allows you to reset both the parent unit and the baby

unit to the default settings at the same time. You can use this function if problems occur that you

cannot solve by following the suggestions in chapter ‘Frequently asked questions’.

1

Select ‘Reset’ with the + and - buttons.

2

Press the OK button to confirm.

, The message ‘Confirm?’ appears on the display of the parent unit.

3

Press the OK button to confirm.

, The parent unit switches off and then switches on again.

, The units have now both been reset to the default factory settings.

Default settings

Parent unit

- Loudspeaker volume: 1

- Microphone sensitivity: 3

- Sound alert: off

- Temperature alert: off

- ‘Temperature low’ alert: 14°C

- ‘Temperature high’ alert: 30°C

Baby unit

- Loudspeaker volume: 3

- Nightlight: off

- Lullaby: 1

EngliSh

14

Advertising
This manual is related to the following products: