Philips AVENT Vigilabebés DECT - Manual (Page 16)

- UK only: SSA-5S-09 UK 075040F
- Other countries: SSA-5W-09 EU 075040F
parent unit
Batteries
Only replace the rechargeable batteries of the parent unit with two rechargeable NiMh AAA
900mAh batteries.
Note: We strongly advise you to use Philips rechargeable batteries.
adapter
Only replace the adapter of the parent unit charger with an adapter of the original type.You can
order a new adapter from your dealer or a Philips service centre.
- UK only: SSA-5S-09 UK 075040F
- Other countries: SSA-5W-09 EU 075040F
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 33).
- Rechargeable and non-rechargeable batteries contain substances that may pollute the
environment. Do not throw away rechargeable and non-rechargeable batteries with the normal
household waste, but hand them in at an official collection point. Always remove rechargeable
and non-rechargeable batteries before you discard and hand in the appliance at an official
collection point.
guarantee and service
If you need service or information or if you have a problem, please visit the Philips AVENT website
at www.philips.com/AVENT or contact the Philips Consumer Care Centre in your country (you
find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
Frequently asked questions
This chapter lists the questions most frequently asked about the appliance. If you cannot find the
answer to your question, contact the Customer Care Centre in your country.
Question Answer
Why don’t the power-on
light of the baby unit and
the LINK light of the
parent unit come on
when I press the on/off
buttons of the units?
Perhaps the batteries of the parent unit are empty and the parent
unit is not in the plugged-in charger. Insert the small appliance plug
into the charger, put the adapter of the charger in a wall socket and
place the parent unit in the charger. Then press the on/off button to
establish connection with the baby unit.
Perhaps the non-rechargeable batteries of the baby unit are empty
and the baby unit is not connected to the mains. Replace the non-
rechargeable batteries or connect the baby unit to the mains. Then
press the on/off button to establish connection with the parent unit.
The baby unit and the parent unit may be out of range of each other.
Move the parent unit closer to the baby unit, but not closer than 1
metre/3 feet.
EngliSh 16