Belkin F1DD102L - Manual (Page 14)

12
Using the KVM Switch
Hot-Key Preceding Sequence Configuration
For users who want to use a preceding sequence other than two consecutive
Scroll Locks, there is also one convenient way to configure it.
1. Press “ScrLk” + “ScrLk” + H, and a beeping sound will signal readiness for
a new preceding sequence selection [or press and hold down the center
of the last front-panel button (Button 2 or Button 4) until you hear three
beeps, then release the button].
2. Select and press the key you would like to use as your preceding
sequence (SCROLL LOCK, CAPS, F12, ESC, NUM LOCK, LEFT_CTRL,
RIGHT_CTRL keys are available for selection), and you will hear a beep for
selection confirmation. Now you can use the new preceding sequence to
execute your hot-key commands.
Note: Each keystroke within a hot-key sequence should be pressed within
two seconds. Otherwise, the hot-key sequence will not be validated.