Belkin F1DD102L - Manual (Page 23)

21
1
2
3
4
5
6
7
8
section
Firmware-Upgrade Guide
Step 9.
Finally, unplug the power cable from the back of the KVM Switch and all other
cables from the KVM Switch, and perform a cold reset. Reconnect all the cables
again to the KVM Switch.
Now you can enjoy the newly added functionality and compatibility of the new
firmware version.
Note: After you have finished the firmware-upgrade process, try the port switching
and other functionalities of the KVM Switch to see whether it works fine with the
new firmware. If it does, then this upgrade process was successfully completed.
Congratulations!
If the file-upload process encounters an error and cannot complete successfully,
please refer to the “Firmware-Upgrade Troubleshooting” section.
Upgrade Using the Mac Version Utility
Prepare your KVM Switch and the Mac Host
Step 1.
Ensure that the power adapter is connected to the KVM Switch. Check to make
sure that the KVM cables for port 1 remain connected to the KVM Switch. The
monitor, mouse, and keyboard should be disconnected from the console port of
the KVM Switch and plugged in directly to the host computer. The power supply
should also remain connected to the KVM Switch.
Step 2.
Power on the Mac host and copy/download the firmware-upgrade utility,
“Belkin Soho.pkg”, and the firmware-upgrade file, “*.blk”, to it.