Bosch BOSCH OVEN - Manual (Page 10)

English 8
Install 2 screws through holes in trim and in range backwall. See Figure 6: Back-
wall Trim Strip and Figure 7: Install Backwall Trim Strip
Connect Electric - Range
Cord
Note: In Canada, the range is shipped from the factory with the range cord
already installed. Continue to “Complete the installation” on page 15.
For installations other than those in Canada, connect the range cord at the termi-
nal block (See next page for detailed instructions). Access the terminal block by
removing the cover in the lower right hand corner of the range back panel.
Install Strain Relief Warning: The strain relief provided with your range cord must be properly
installed.
Place strain relief in knockout below terminal block. See Figure 8: Strain Relief
Knockout. Feed range cord through hole and strain relief up to terminal block.
Allow for slack in the cord between the strain relief and terminal block. Once cord
Figure 6: Backwall Trim Strip
Figure 7: Install Backwall Trim Strip
Backwall
Trim Strip
Back of Range