Bosch BOSCH OVEN - Manual (Page 14)

English 12
6. Attach black wire, round washer, star washer and nut IN THIS ORDER to right
post.
7. Tighten all connections securely and replace terminal block cover.
8. Properly secure strain relief. See “Install Strain Relief” on page 8 for detailed
instructions.
Connect Electric - Flexible
Conduit Connection
The range can also be connected via flexible conduit. If using this method, always
use the lugs supplied.
Note: In Canada, the range is shipped from the factory with the range cord
already
installed. Continue to “Complete the installation” on page 15.
Four Wire Flexible Conduit Connec-
tion
1. Disconnect electrical power at the breaker box.
2. Remove the terminal block cover to expose the terminal block.
3. Remove the top nut, star washer, and round washer from each post.
Note: DO NOT remove last round washer, last nut or internal wire leads.
4. Remove screw from bottom end of ground strap.
5. Remove ground strap from center post. Discard.
6. Attach one terminal lug (packaged with this manual) through hole below termi-
nal block with ground screw.
7. Place one terminal lug (packaged with this manual) on each post. Replace the
star washer and round washer and secure with 20 inch pounds of torque.
Figure 14: Three Wire Connection
Figure 15: Completed Three Wire Range Cord Connection
red
white
black
ground strap
green ground screw