Bosch BOSCH OVEN - Manual (Page 15)

English 13
8. Strip 3/8 (9.53 mm) inches of insulation from the end of the wire.
9. Insert the insulated grounding wire into the lug below the terminal block.
10. Insert stripped end of white wire into the center lug. Secure the clamping-
screw.
11. Insert stripped end of red wire into the left lug. Secure clamping screw.
12. Insert black wire into the right lug. Secure clamping screw. Tighten each
clamping screw with the appropriate torque (see table).
13. Properly secure flexible conduit at knockout on angle and at supply side junc-
tion box. The wiring is now complete.
Figure 16: Wire Stripping
Figure 17: Attaching Wire to Lug
Table 3: Appropriate Torque Levels for Aluminum or Copper Wire
Gauge Torque (in./lbs.) Torque (Nm)
6 35 3.95
8 25 2.82
Figure 18: Completed Four Wire Flexible Conduit Connection
3/8 “
lug
clamping screw
wire
red wire
white wire
green
ground
screw
black wire
green ground wire