Brocade Communications Systems Brocade ICX 6650 53-1002599-01 - Manual (Page 42)

26 Brocade ICX 6650 Hardware Installation Guide
53-1002599-01
Connecting network devices
3
Deleting an IP address
Enter a command similar to the following to delete an IP address.
Brocade(config-if-1/1/1)# no ip address 1.1.2.1
This command deletes IP address 1.1.2.1. You do not need to enter the subnet mask.
To delete all IP addresses from an interface, enter the following command:
Brocade(config-if-1/1/1)# no ip address *
Syntax: no ip address ip-addr | *
Connecting network devices
Brocade devices support connections to other vendors’ routers, switches, and hubs, as well other
Brocade devices.
Connectors
For port pinouts, refer to “Pinouts and signalling” on page 50.
Connecting a network device to a fiber port
For direct attachment from the device to a Gbps NIC, switch, or router, using a fiber optic
transceiver, you will need fiber cabling with an LC connector.
For information about transceivers supported on ICX 6650 devices, refer to the following Brocade
website:
http://www.myBrocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_
DS.pdf
To connect the device to another network device using a fiber port, you must do the following tasks:
• Install a fiber optic transceiver (SFP, or SFP+)
• Cable the fiber optic transceiver
The following sections describe these tasks.