Led patterns – Brocade Communications Systems Brocade ICX 6650 53-1002599-01 User Manual
Page 48
32
Brocade ICX 6650 Hardware Installation Guide
53-1002599-01
LED patterns
4
LED patterns
The following sections describe the Brocade ICX 6650 LED patterns.
PSU 1 and PSU2
DIAG LED
Management port status LED
1/10 GbE SFP+ port LEDs
40 GbE GSFP+ rear port LEDs on front panel
LED State
Status of hardware
Recommended action
Off (no light)
System is off or there is no power.
Verify the system is on and has
completed booting.
Steady green
PSU is on and functioning properly.
No action required.
Steady amber
PSU is in faulty state or missing power.
Replace power supply.
LED State
Status of hardware
Recommended action
Off (no light)
Diagnostic is off.
No action required.
Blinking green
System self-diagnostic test is in progress.
No action required.
Steady green
System self-diagnostic test is successfully
completed. Device reboot and clears back to off.
No action required.
Steady amber
System self-diagnostic test has detected a fault. Contact support.
LED State
Status of hardware
Recommended action
Off (no light)
Not cabled.
No action required
Blinking
There is traffic and packets are being
transmitted or received.
No action required.
Steady
No traffic being transmitted, but link is up.
No action required.
LED State
Status of hardware
Recommended action
Green
Link is up in 10 GbE mode.
No action required.
Blinking green
There is 10 GbE activity (traffic) and packets are
being transmitted or received.
No action required.
Amber
Link is up in 1 GbE mode.
No action required.
Blinking amber
There is 1 GbE activity (traffic) and packets are
being transmitted or received.
No action required.
LED State
Status of hardware
Recommended action
Off (no light)
Not enabled.
No action required.
Blue
Link is up in 40 GbE mode.
No action required.
Blinking blue
Indicates activity, and packets are being
transmitted or received.
No action required.