Brother HL 2700CN - Manual (Page 122)

ROUTINE MAINTENANCE 5 - 17
3) Remove the transfer belt cover.
Figure 5-21
4) Remove the transfer belt cleaner by grasping the handle and lift it up.
Figure 5-22
5) Clean the area where the new transfer belt cleaner is to be installed with a dry cotton cloth.
Figure 5-23
6) Put the new transfer belt cleaner into the printer by gently placing the brass bearings into the
guides, and then pushing the handle down until the bearings click into place. Make sure the
transfer belt cleaner is free to move slightly upwards (rotating slightly around the bearings) in