Brother HL 2700CN - Manual (Page 26)

ABOUT THIS PRINTER 1 - 8
Positioning the printer
Please read the following before you use the printer.
Power Supply
Use the printer within the recommended power range.
AC power: ±10% of the rated power voltage
Frequency: 50/60 Hz (120 V or 220-240 V)
The power cord, including extensions, should not exceed 5 meters (16½ feet).
Do not share the same power circuit with other high-power appliances, such as an air conditioner, copier,
shredder and so on. If you cannot avoid using the printer with these appliances, we recommend that you
use a voltage transformer or a high-frequency noise filter.
Use a voltage regulator if the power source is not stable.
Environment
■
Make sure that the power outlet/socket is near the printer and is easy to get to so that, if there is an
emergency, it can be easily unplugged.
■
Use the printer only within the following ranges of temperature and humidity:
Temperature: 10 °C to 32.5 °C (50 °F to 90.5 °F)
Humidity: 20% to 80% (without condensation)
■
Do not put the printer where the ventilation hole of the printer is blocked. Keep a gap of approximately
100 mm (4 in.) between the ventilation hole and the wall.
■
The printer should be used in a well-ventilated room.
■
Put the printer on a flat, horizontal surface.
■
Keep the printer clean. Do not put the printer in a dusty place.
■
Do not put the printer in direct sunlight. If you have to put it near a window, use a blind or a heavy
curtain to protect the printer from direct sunlight.
■
Do not put the printer near devices that contain magnets or generate magnetic fields.
■
Do not subject the printer to strong physical shocks or vibrations.
■
Do not expose the printer to open/naked flames or salty or corrosive gasses.
■
Do not put objects on top of the printer.
■
Do not put the printer near an air conditioner.
■
Keep the printer horizontal when you carry it.
■
Do not place anything on top of the power cord including this machine. Do not allow the power cord
to be stepped on.