Barco ICON H250/400 R9010510 - Manual (Page 44)

6. Setup
7. Press ENTER
Always select the highest rate (115200) unless otherwise specified.
6.9 Setting the server ON/OFF state
Starting up
The Server (desktop) will always be displayed at projector startup, it can however still be shut down and re-started via the General
menu.
During the standby state of the projector the Server can be chosen to be active or inactive, this is done by defining the state of the
Server during a “Projector standby state” .
It is recommended to leave the server ON even when the projector is in standby to allow the use of the full
network capabilities.
Manual start up: How to start up/shut down/reset the Server ?
1. Press MENU to activate the Tool bar
2. Press → to select General
3. Press ↓ to Pull down the General menu
4. Use ↑ or ↓ to select iCon Server
5. Press → to open the menu
6. Use ↑ or ↓ to select ON/OFF/Reset
Image 6-14
7. Press ENTER
When resetting the Server the menu items in the Server menu are greyed out during a short period.
Projector standby state: How to set the projector standby state ?
1. Press MENU to activate the Tool bar
2. Press → to select Installation
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select iCon Server settings
38 R5976992 ICON H250/400 13/12/2006