Barco ICON H250/400 R9010510 - Manual (Page 65)

7. Advanced
• Contrast
• Brightness
• Phase
• Input balance
• AutoImage : or manual edit of the image file settings
7.3.5 PC
When
Select PC when you are in presence of a data signal of the RGB + sync form connected to the D15 input connector of the projector.
An RGB data signal can have its sync signal added in different ways, refer to the Installation section for more
information on the RGB+sync signals accepted by the PC input.
How to select the PC input ?
1. Press MENU to activate the Tool bar
2. Press ↓ to Pull down the Source Selection menu
3. Use ↑ or ↓ to select L3 PC
Image 7-6
4. Press ENTER to confirm your choice
A bullet indicates the selected composite video source which now appears on the screen.
7.3.6 DVI
When
The projector is equipped with 2 DVI inputs, one located on the layer 1 and the other on layer 3.
Select DVI when in presence of digital data signal connected to a DVI input of the projector. These signals are often available on a
PC or other image generator.
How to select the DVI input on layer 1 ?
1. Press MENU to activate the Tool bar
2. Press ↓ to Pull down the Source Selection menu
3. Use ↑ or ↓ to select L1 DVI
Image 7-7
4. Press ENTER to confirm your choice
A bullet indicates the selected composite video source which now appears on the screen.
R5976992 ICON H250/400 13/12/2006 59