Billion Electric Company BiPAC 8501/8521 - Manual (Page 161)

Billion BiPAC 8500/8501/8520/8521 SHDSL (VPN) Firewall Bridge/ Router
Chapter 4: Configuration
157
For Example: User A changes HTTP port number to 100, specifies their own IP address of
192.168.1.55, and sets the logout time to be 100 seconds. The router will only allow User A
access from the IP address 192.168.1.55 to logon to the Web GUI by typing:
http://192.168.1.254:100 in their web browser. After 100 seconds, the device will automatically
log User A out.
Universal Plug and Play (UPnP)
UPnP offers peer-to-peer network connectivity for PCs and other network devices, along with
control and data transfer between devices. UPnP offers many advantages for users who run
NAT routers through UPnP NAT Traversal, and on other supported systems. User can perform
various tasks more easily such as port forwarding by letting the application control the required
settings, removing the need for the user to control advanced configuration of their device.
Both the user’s Operating System and the relevant application must support UPnP in addition to
the router. Windows XP and Windows ME natively support UPnP (when the component is
installed), and Windows 98 users may install the Internet Connection Sharing client from
Windows XP in order to support UPnP. Windows 2000 does not support UPnP.
• Disable: Check to disable the router UPnP functionality.
• Enable: Check to enable the router UPnP functionality.
• UPnP Port: Its default setting is 2800. It is highly recommended for users to use this port
value. If this value conflicts with other ports already used, you may change the port.
SNMP Access Control (Software on a PC within the LAN is required in order to utilize this
function) – Simple Network Management Protocol.
SNMP V1 and V2:
• Read Community: Specify a name to be identified as the Read Community, and an IP
address. This community string will be checked against the string entered in the
configuration file. Once the string name is matched, user who obtains this IP address will
be able to view the data.
• Write Community: Specify a name to be identified as the Write Community, and an IP
address. This community string will be checked against the string entered in the
configuration file. Once the string name is matched, user from this IP address will be able
to view and modify the data.
• Trap Community: Specify a name to be identified as the Trap Community, and an IP
address. This community string will be checked against the string entered in the
configuration file. Once the string name is matched, user from this IP address will be sent
to SNMP Traps.