ARB RD110 - Manual (Page 15)

3 Installing the Air Locker
13
3.4 Installing the Carrier Bearings
c Apply a thin film of high pressure grease to both bearing journals of
the Air Locker.
c Using a bearing press or arbor press, press one of the original
tapered roller bearing cones onto the bearing journal opposite to
the ring gear flange of the differential carrier (As shown in Figure 5.)
until the bearing seats firmly against the bearing journal shoulder.
Figure 5.
c Invert the Air Locker and press the bearing cone which was
supplied with the Air Locker kit onto the bearing journal on the ring
gear flange side of the differential (the seal housing side) until the
bearing seats firmly against the bearing journal shoulder.
NOTE : Never re-use any bearings which are damaged or
worn. Do not add any shims between the seal
housing bearing and the bearing seat.