ARB RD110 - Manual (Page 6)

1 Introduction
4
1.2 Tool-Kit Recommendations
Below is a list of tools and supplies you may need to complete this
installation. Requirements for your vehicle may vary. Please consult
your vehicle service manual for additional recommendations.
1.2.1 Tools
c Standard automotive sizes (metric and/or imperial) of sockets,
wrenches, Allan keys, and drills.
c A dial indicator or other suitable measuring tool for checking ring &
pinion backlash.
c A razor knife for nylon tubing.
c A differential housing spreader to facilitate removal and installation
of the carrier.
c A torque wrench (See vehicle service manual for required torque
range)
c A lubricant drain reservoir.
c A slide hammer for removing CV axles.
c Suitable measuring tools to measure a differential for preload
shimming. (e.g., an automotive feeler gauge)
c A 11.2mm [7/16”] drill and ¼”NPT tap for bulkhead fitting
installation.
c An automotive bearing puller (2 jawed) or a differential carrier
bearing puller.
c A bearing press or arbor press.
1.2.2 Supplies
c Thread lubricant/sealant compound for pressure fittings
(e.g., LOCTITE #567 Teflon paste)
c Thread locking compound (e.g., LOCTITE #272)
c A gasket sealant or replacement gasket for your differential.
c A sufficient volume of differential oil to completely refill your
housing. (see the ARB Air Locker Operating and Service Manual
for recommended lubricants)
c A soap and water mixture to test for air leaks.
c A selection of differential bearing shims to set-up preload and
backlash.