3 installing the air locker, Clamshell housing installation – ARB RD90 User Manual
Page 25
Advertising
3 Installing the Air Locker
23
3.9.2
B
Clamshell Housing Installation
c Assemble the shim pack ‘E’ (Fig.9.) into the bearing bore of the
shallow half of the clamshell.
c Position the seal housing in the same bearing bore so that the end
of the seal housing tube is in line with the bulkhead port position
(Refer to Figure 15.).
Figure 15.
c Using a bearing press or arbor press, press the seal housing
assembly into the bottom of the bearing bore (i.e., until it stops
against the shim pack).
NOTE :
Do not use excessive force when pressing as this may
damage the seal housing assembly.
HINT :
You should not be able to rotate the shim pack
underneath the bearing cup if it has been pressed in
far enough.
Advertising