ARB 3520030 - Manual (Page 13)

Last Rev Date: 18/07/11 Page 13 of 15 Fitting instructions# 3787968
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
FROM SUPPLEMENTARY KIT 3520020
48. Fit the cage nuts to the inside faces of the
wing under panels as shown
49. Fit the wing under panels as shown using M6
bolts and washer sets to bolt to wing
underside
If there is a corresponding hole in the chassis
brace lower flange to fix inside flange of the
sing under panels....
50. Use M8 x 25mm bolts, washer sets and
flange nut to bolt to chassis brace lower
flange
If there is no corresponding hole in chassis
brace lower flange to fix inside flange of the
wing under panels....
51. On the RH side, lift the inner locating flange
up to the chassis reinforcing bracket lower
flange, position centrally then mark and drill a
Dia 7mm (11/32”) hole through the existing
reinforcing bracket flange. Repeat for LH side
52. Touch up holes with rust preventing paint
53. Use M8 x 25mm bolts, washer sets and
flange nut to bolt to chassis brace lower
flange
If wing panels are fitted...
54. Drill 2 x Dia 7mm (5/16”) holes in each fender
liner lining up with the cage nuts in the rear
flanges of the wing under panels so the liners
can be fastened to the rear flange
55. Fix in place using 2 x M6 x 20 Bolts and
washer sets per side
Warning: Drilling operations can
result in flying metal debris, safety
glasses should be worn.
Warning: Drilling operations can
result in flying metal debris, safety
glasses should be worn.