ARB 3520030 - Manual (Page 6)

Last Rev Date: 18/07/11 Page 6 of 15 Fitting instructions# 3787968
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
9. Check that the nut body is completely
removed, if it is not cleared, using a cold
chisel and hammer chisel the remainder off.
10. Fit an M12 cage nut to each of the captive
nut plates 3193741.
11. Fit the chassis mount braces to the vehicle
using the M12 x 30mm fine pitched bolt, M12
spring and flat washers supplied in the lower
hole. Use an M12 flat washer as a spacer
between the brace and the chassis at the
upper hole and fix with an M12 x 40mm bolt
M12 spring and flat washers and M12 x 1.75
nut. Do not tighten the bolts.
12. Insert the captive nut assembly through the
front of the chassis and line it up with the hole
at the end of the mount brace. Fix in place
with the M12 x 1.75 x 40mm bolt, M12 flat
and spring washers. Break off the end of the
captive nut plate. Do not tighten yet.
Use a M12
flat washer
as a spacer
between
chassis and
bracket.
Warning: Hammering and
chiselling operations can result in
flying metal debris, safety glasses
should be worn.