Fitting procedure, Fitted product on vehicle – ARB 3520030 User Manual
Page 15
Last Rev Date: 18/07/11
Page 15 of 15
Fitting instructions# 3787968
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
60. Feed a cable tie through holes and secure.
61. The painted color coded area of vehicle
visible in the region around the trimmed
fender liner may be spray painted black to
hide this area.
NOTES:
When finished make sure all bolts are tightened and that all wiring
is clear of hot, sharp and moving parts.
Also supplied in the kit are two 3/8” rubber grommets and two 16mm plugs.
The rubber grommets are for the two holes in the top pan if lights are being
fitted. The two plastic plugs are for the holes in the top surface of the wings
if no CB aerials are going to be connected.
CAUTION: If winch fitted, check that the air conditioner piping is clear of the
winch by at least 20mm (3/4”). Fit a sheath around tubing and secure with
cable tie to prevent chaffing which may lead to piping damage.
FITTED PRODUCT ON VEHICLE