ARB 3432120 - Manual (Page 4)

21/05/07 Page 4 of 8 3783040
5.& 6 .
5. When drilling the vertical pinning bolt THE DRILL
MUST BE VERTICAL IN BOTH DIRECTIONS
failure to do so will result in damage to the radiator
mounting system .
Drill out both holes and assemble using the long M10
bolts and hardware supplied .
From the out board side of the chassis insert the
chassis packers between the under side of the chassis
and the impact absorber with the finger tab facing
downward .
Repeat this on the LHS .
6.
The plastic air shield needs to be trimmed before being
replaced , cut the holes ( located on the edge tabs )
into an open ended slot .
Place the shield back into its original position and
screw across the back edge in 3 locations .
The edge tabs are now pushed in on top of the packer ,
the tabs are retained when the vertical bolts are done
up and sandwiched between the chassis and
the chassis spacer .
Re – confirm the measurement between the impact
absorbers to ensure the bull bar will fit onto the
vehicle and tighten all of the vertical bolts .
7.
7. Remove the horizontal bolts only , as previously
described in step 3.
Re – assemble but this time the tubular cross brace
and the original recovery point are attached .
Note the recovery bracket is located to the left
hand chassis rail, and uses the longer metric
M10 bolts .