ARB 3432120 - Manual (Page 6)

21/05/07 Page 6 of 8 3783040
11.
11 WINCH BAR ONLY The roller fair lead must be
drilled prior to fitment , it can then be assembled into
the front of the bull bar along with the winch as
detailed in step 14 .
Using a 13.0 mm drill bit drill two holes as shown
in diagram 11.
The roller fair lead can then be fitted into the
bull bar.
12.
12 To place the winch clutch handle in an accessible
location, the gearbox must be rotated 2 bolt spaces
( 144 degrees ) in an anti-clockwise direction when
viewed from the gear box end .
Place the winch on its end and remove the gear box
bolts .Gently raise the gear box just enough to rotate
it ( about 5mm ) , DO NOT COMPLETLEY
remove the gear box as this will damage the gasket .
Once in the new position refit all gear box bolts and
tighten .
13.
13 The winch motor must also be rotated 90 degrees
in a clockwise direction when viewed from the
motor end .
Place the winch on its end and remove the 2 bolts
holding the motor to the body .Gently raise the motor
just enough to rotate it .
Once in the new position re-fit the 2 bolts and tighten