ARB 3432120 - Manual (Page 5)

21/05/07 Page 5 of 8 3783040
8.
8. Placing the original bumper bar face down on a
blanket remove all of the screws that hold the painted
outer section to the main bumper .Using pliers remove
the clip that holds the washer nozzle in the bumper
and take out the nozzle ( both sides ) .These are re-
fitted into the bull bar once the fog lamp and turn
signal are installed .
Using a small flat bladed screw driver dis-engage the
locking tabs on both sides and remove the cover , this
will enable the fog lamp to be un-screwed in three
places and removed .
9.
Fit the “u” nuts to the fog lamp bracket , the nylon
washer fits between the bracket and the lamp
mounting foot ( located on the adjustment side ) fit
the fog lamp with the screws provided . Fit the screw
covers over the exposed end of the screws in 3 places
to each bracket.
Fit the M6 cage nuts into the large square holes in the
edge flange of the fog lamp bracket . From the inside
of the bracket , Squeeze the two legs of the cage nut
together and fit to the hole . NOTE :- The body of
the nut is closest to the fog lamp .
The Right hand fog lamp is shown .
Insert the nylon plugs into the square holes in the turn
signal aperture , located on the inside face of the bull
bar . From the rear , screw the turn signal assembly to
the bracket on the bull bar , with the clear portion of
the lens to the outboard edge .
Re-fit the washer nozzle both sides once the fog lamp
& turn signal are fitted . The washer retaining clip may
need to be flattened slightly to fit .
10.
10 When fitting a winch only :- Fit the control box
bracket to the bull bar using the M8 x 20 mm bolts
and hardware , with the open end of the bracket
facing the grill . Leave these bolts finger tight at this
stage .
Fit the grommet to the hole in the top of the bull bar
and feed the control box cables through
the grommet .