ARB 3432150 - Manual (Page 14)

19-03-08 Page 14 of 21 3783182
WINCH FITMENT
41. Remove the cap head screws retaining
the gearbox to the winch drum. Carefully
lift and rotate the gearbox 144 degrees
counter clockwise (four hole spacings)
and re-fit the cap screws.
42. Lay the winch on a suitable surface and
place the bull bar on top so that the wire
rope will feed from the bottom.
43. Using two 3/8” x 1 1/2” bolts, M10 flat and
spring washers, attach the bull bar to the
winch through the top two holes
44. Using a 12mm drill bit, drill two new holes
in the roller fairlead 25mm below the
original holes.
Drill the new
hole 25mm
below original