ARB 3432150 - Manual (Page 21)

19-03-08 Page 21 of 21 3783182
WASHER BOTTLE GUARD FITMENT TO BULL BAR
77. Install the cage nut into the cage nut
bracket as shown below .
78. Insert the cage nut bracket up through the
access hole and line up the hole in the
fender liner and bottle guard , use the M6
hardware supplied to bolt the fender liner
to the washer bottle guard .
Repeat for the lower hole and for the Left
hand side . Break off the excess length
of cage nut bracket when finally
secured .
79. Trim the inner guard in line with the lower
edge of the washer bottle cover .
80. Using the washer bottle guard as a
template mark the position of three cage
nuts located on the rear fold with a paint
marker onto the fender liner .
Drill Using a 8 mm drill bit - drill the three
holes .
81. To fit the license plate to the bar, first
push two nylon plugs into the front face of
the top pan. Fit the license plate using two
8-18 x 20mm tek screws .
82. Ensure all lights are functioning correctly
and all bolts are fully tightened .
Also supplied in the kit are two 16mm plugs. The two plastic plugs are for the holes in the top
surface of the wings if no CB aerials are fitted.