ARB 3450120 - Manual (Page 10)

29/8/05 Page 10 of 12 3783172
32. If bar is going to be a non-winch bar, fit
number plate directly to front of bar using
6mm hardware.
33. To fit cover plate on top of bar winch cut-
out, fit rubber extrusion around top cover
panel, trim to size and bolt to top of bar using
M6 button head stainless steel screws and M6
flange nuts.
34. If fitting fog lights removed at step 2,
fasten the fog lights to the brackets provided
as shown in the adjacent photo.
The black plastic fastener was taken off the
original bumper and re-used here.
Alternatively, if no fog lights are being fitted to
the bar, assemble the aperture covers to the
aperture cover brackets using the self-tapping
screws provided.
35. Fit the fog lights to the bull-bar, or the
aperture covers, with the M6 hardware. Next
connect the fog lights and the blinker /
clearance lamps to the looms fitted at steps 15
& 16.