ARB 3450120 - Manual (Page 9)

29/8/05 Page 9 of 12 3783172
28. Cable tie power leads to battery, to the left
side of the bar keeping clear of all moving
parts.
(Viewed from rear of bar)
29. Slide bar onto vehicle mounting system
and secure using 10mm hardware. Place rags
between the bar and the vehicle’s grill to avoid
the grill being scratched.
Prior to bolting the bar in place ensure the
vehicles mudguards are tucked inside the
wings as shown on the adjacent photo.
Align bar with vehicle grille and flares, and
tighten bolts using socket, extension and uni
joint through fog light aperture in bar. The
vertical gap between the vehicle’s flares and
the top of the bull-bars wings should be 16mm.
Lastly retighten the mounting system bolts
when bar has been centralized sideways.
30. Once the bar is in position, fasten the
wheel liners to the bar using the M6 hardware.
Drill through the wheel liner using the lower
wing hole and fasten.
31. Once bar is secured to vehicle, using holes
in locking plates as a template, drill 10mm
holes through lower section of bar and bolt up
using 10mm hardware.