ARB 3450120 - Manual (Page 7)

29/8/05 Page 7 of 12 3783172
17. Fit the M6 cage nuts to the bull-bar to
mount the fog lights.
Fit the nylon plugs, used to mount the
indicator / clearance lamps.
Fit the M6 cage nuts to mount the washer
bottle / horn stone guards.
18. Remove the fastening screws and nuts
supplied with the turn signal/clearance lamps
and replace these with the four screws
provided in the kit. Fasten the lamps to the
bar as shown.
IMPORTANT
The turn signal is to the inside of the bar.
19. If bar is to have a winch fitted, follow the
next steps.
20. Fit number plate bracket to bar using
6mm hardware. (20mm x 6mm bolts) Fit
number plate to number plate bracket using
6mm hardware when bar is fitted to vehicle.
21. Fit control box bracket to bar using 8mm
hardware.
22. Drill 12mm holes under existing holes
25mm lower down the same pitch as existing
holes, these will be the holes used to bolt to
bar.
VIEW OF THE CENTRE OF BAR
NEW HOLES