ARB 3452030 - Manual (Page 11)

Last Rev Date: 10-Feb-2007 Page 11 of 15 Fitting instructions# 3783246
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE WINCH
31. Viewed from front of vehicle the winch clutch
(handle) must be positioned on the LH side
(same side as smaller square access hole in
pan). Cable must spool from the bottom of
winch. Draw off enough cable so cable crimp
can be pulled through roller fairlead.
32. Bolt winch in position with the roller fair lead
in place.
Hint: To increase access to mount bolts in front of
roller fairlead, remove circlips from bottom of each
vertical roller shaft, push shaft up so roller can be
dislodged sideways. Do up bolts in fairlead and
winch, then refit circlip.
33. Connect the winch control box cables to the
winch motor. Refer to the Warn handbook for
additional information. Connect the long
winch + & - cables to the vehicle after the bar
is installed. Refer to the Warn winch
manual for vehicle wiring instructions.
34. Fitting number plate – with winch
Bolt number plate to the bracket with the M6 X
16mm bolts and M6 flange nuts through the
lower holes of the number plate.
If not fitting winch.
Bolt the number plate through the top holes
using M6 X 16mm bolts and M6 flange nuts.
35. If not fitting winch cont.
36. Wrap rubber extrusion around winch cover.
37. Place washers over the winch cover fixing
holes located on the top middle face of the
winch bumper.
38. Place the winch cover on top of the winch
bumper inline with the mount holes.
39. Bolt together using the M6 button head
stainless steel screws and M6 nuts.
View from above, rear of bull bar