Removal of bumper – ARB 3452030 User Manual
Page 5
Last Rev Date: 10-Feb-2007
Page 5 of 15
Fitting instructions# 3783246
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
REMOVAL OF BUMPER
1.
If fog lights fitted in bumper, undo fog light
loom connection (connection located on LHS
of bumper)
2.
Remove bumper by undoing 4 x M12 nuts on
‘U’ bolts through chassis and withdrawing
bumper off chassis mount position, set aside.
Retain bumper retaining ‘U’ bolts and nuts.
Note: For 2500 turbo diesel shown (and 3500
TD), undo and remove intercooler top mount
bolts and rubber suspension blocks, this will
allow the intercooler to tip back at the top and
clear of the bumper U bolts allowing removal).
3.
If OE fog lights fitted and are required for re-
fitment into bull bar, remove each light and
bracket assembly and then remove lights as
shown by prising the lug each side from the
case and undoing the adjuster screw.
4.
Also, if OE fog lamps are to be reused,
remove fog lamp loom fitted to bumper for re-
use.
Prise open to
remove lug