Fitting procedure bar on vehicle – ARB 3452030 User Manual
Page 14
Advertising
Last Rev Date: 10-Feb-2007
Page 14 of 15
Fitting instructions# 3783246
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE BAR ON VEHICLE
51. Note that the aperture moldings are handed
(RH or LH), select correct hand for each wing
aperture. Apply Sikaflex to recess in aperture
molding flange then fit to aperture in wing.
Use adhesive tape to secure plastic mold
while Sikaflex cures.
52. Use adhesive tape to secure plastic mold
while Sikaflex cures.
53. Wire up indicators and running lamps. Wire
loom extensions are supplied in fitting kit.
54. If winch fitted, fit off winch hook.
Advertising