ARB 3452030 - Manual (Page 15)

Last Rev Date: 10-Feb-2007 Page 15 of 15 Fitting instructions# 3783246
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE BAR ON VEHICLE
55. Trim fender liner with air hacksaw or similar
tool along line as shown. Cut away the
outboard flap, which normally fits in the end
of the bumper wing. This is so the liner can
be held back easily by the retaining bracket at
step 56.
56. Fit liner retainer bracket with black M6 bolt
and washer sets into M6 cage nuts in wing
returns each side as shown.
FITTED PRODUCT ON 1500 MODEL
Cut along
this path