ARB 3452030 - Manual (Page 6)

Last Rev Date: 10-Feb-2007 Page 6 of 15 Fitting instructions# 3783246
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE GENERAL
FOR 1500 MODEL VEHICLES
FOLLOW STEPS 5 - 11, FOR 2500
AND 3500 VEHICLES STEPS 12 – 18.
5. Fit mount brackets to chassis end plates, fit
reinforcing brackets behind flanges as
shown. Fasten using M12 x 40 bolts, washer
and nut sets, but only nip up hand tight at
this stage..
6. Align bracket set evenly on vehicle so that
the outside measurement across vertical
bracket plates is 1008-1012mm.
7. Do fasteners up tight, ensuring that
reinforcing bracket is sitting snugly against
chassis side face.
8. Recheck 1008-1012mm pitch, readjust if
necessary.
NOTE: Distance between uprights in bull bar is
1013mm.
9. Drill 1 x M10 pinning hole in chassis using
existing hole in reinforcing bracket as a
guide.
10. Fit the M10 cage nut to nut plate as shown.
Warning: Drilling operations can result in
flying metal debris, safety glasses should be
worn.
View from rear
showing location
of reinforcing
bracket on RHS
View showing layout of
mount brackets – note: set
distance outside of flanges
at 1008 and 1012mm.
1008-1012mm