ARB 3438260 - Manual (Page 11)

Last Rev Date: 26/6/2009 Page 11 of 18 Fitting instructions# 3787027
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
BULL BAR PREPARATION
40. Fit the buffers to either side of the bull bar
using 6 x M6 flange nuts. Do not over
tighten.
41. Fit M6 cage nuts to four holes in lower pan
flange. The nut bodies are inside the bull
bar
IF NOT FITTING A WINCH
42. Apply rubber mould to edge of winch
hole cover panel and trim off excess.
43. Fit panel to top face on bull bar using 2 x M6
dome head stainless steel screws, flange
nuts and flat washers.
NOTE: The flat washers are to be sandwiched
between panel and top face of bull bar to stop
the panel pulling down to form depression
around screw heads.