ARB 3438260 - Manual (Page 14)

Last Rev Date: 26/6/2009 Page 14 of 18 Fitting instructions# 3787027
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
WINCH FITMENT ONLY
52. Attach the control box to the control box
bracket as shown.
53. Fit the control box to the bull bar with two M8
x 25mm bolts, M8 flat washers and M8 flange
nuts.
54. Run the cables through the rubber grommets
and connect to the winch as per the wiring
diagram supplied with the winch.
55. Using cable ties fix the cables securely and
ensure they are well away from any moving,
sharp or hot surfaces.
BULL BAR FITMENT TO VEHICLE
56. With assistance guide the bull bar into
position on the vehicle. The uprights on the
bull bar sit inside the impact absorber blades.
57. Bolt the bull bar into position using the M12
bolts, spring washer, large body washer and
flange nuts 3 places each side as shown.
Tighten the bolts firmly – but allow enough
movement for the bull bar to be adjusted