Winch fitment only – ARB 3438260 User Manual
Page 13
Last Rev Date: 26/6/2009
Page 13 of 18
Fitting instructions# 3787027
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
WINCH FITMENT ONLY
48. Using a 12mm drill bit, mark & drill two new
holes in the roller fairlead 25mm below the
original holes.
49. Remove the cir clips from the bottom of the
vertical rollers of the fairlead and push the pin
upwards. Push the vertical rollers inwards on
the lower edges as shown and using two 3/8”
x 1 ¾” bolts M10 flat and spring washers,
attach the lower section of the roller fairlead
to the bull bar and winch.
50. Replace the cir clips on the vertical rollers
on both sides.
51. Insert the two rubber grommets into the top
face of bull bar.
Drill the new
hole 25mm
below
Warning: Drilling operations can result in flying
metal debris, safety glasses should be worn.