ARB 3952010 - Manual (Page 5)

22/06/06 Page 5 of 9 3782946
7. Fasten the top hole using M10 bolts, M10 flat
washers and M10 spring washer.
8. If fitting winch.
The clutch handle must be repositioned so it is in a
convenient location when mounted to bar.
Place the winch on its end and remove all gearbox
bolts.
Gently raise the motor just enough to rotate it.
Viewing from the gearbox end, rotate the gearbox
72deg clockwise.
Do not completely remove the motor and avoid
damaging the gasket.
Refit and tighten all bolts.
NOTE: Take care not to lift the assembly more
than a couple of millimeters while rotating to the
desired position to avoid unmeshing the gears.
9. If fitting winch.
The three control box leads, which connect to
winch, need to be replaced with the longer leads
supplied in the fitting kit. Replace the leads with
similar colours.
Bolt the control box bracket to the control box, refer
photo.
Thread the cable ties through the slots in the
bracket and tie down the cables to the bracket as
shown in photo.
ORIGINAL POSITION NEW POSITION
ROTATION