ARB 3952010 - Manual (Page 9)

22/06/06 Page 9 of 9 3782946
19. There are two Ø16 holes located on the top face of
the bar. If no CB aerials are fitted the holes can be
covered with the plastic plugs provided in the fitting
kit.
Place the ARB logo on the front face of the bar in
the indentation.
20. If fitting fog lights, wire the fog lights as described in the fog light fitting instructions.
The fog lights can be adjusted to desired angles by the adjustment bolts located at the back of the light
insert. When adjustment is finalized, be sure to retighten the fog light bolts.
If fitting with winch.
21. Connect the long winch + & - cables to the vehicle after the bar is installed.
Refer to the Warn winch manual for vehicle wiring instructions.
Ensure that these cables are installed well clear of sharp, hot or moving objects. Secure the winch cables to
the vehicle and winch bumper with the supplied cable ties.
Optional Extras suited for this bar includes a range of IPF driving lights and fog lights (Kit no. 9381FCK).
Contact you’re nearest ARB stockiest for further information.