ARB 3952010 - Manual (Page 6)

22/06/06 Page 6 of 9 3782946
10 If fitting winch.
Mount the control box assembly to the bar and
fasten to the winch mount bracket using M8 bolts,
flat washers and spring washers. Run the cables
through the cutout on the passenger side and
cable tie through the slots on the return.
11. If fitting winch.
Position the winch inside the bar cradle with the
clutch handle positioned on the drivers side. Cable
spools from the bottom. Bolt in position with the
roller fair lead in place.
Connect the winch control box cables to the winch
motor. Refer to the Warn handbook for additional
information. Connect the long winch + & - cables to
the vehicle after the bar is installed. Refer to the
Warn winch manual for vehicle wiring instructions.
12. If not fitting winch.
Wrap rubber extrusion around winch cover.
Place washers over the winch cover fixing holes
located on the top middle face of the winch
bumper.
Place the winch cover on top of the winch bumper
inline with the mount holes.
Bolt together using the M6 button head stainless
steel screws and M6 nuts.