ARB 3915040 - Manual (Page 10)

Last Rev Date: 28 OCTOBER 2008 Page 10 of 22 Fitting instructions# 3781218
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
REMOVAL OF BUMPER Cont.
25. Bumper can now be carefully removed
and placed on a clean, non abrasive, soft
surface face down. It is best to do this
with the help of another person.
NOTE: As bumper is being removed, check
that all wiring looms etc are disconnected
26. Remove grille from bumper cover by
releasing plastic tabs as shown
27. Remove fog light brackets and fog lights
if fitted and set aside, these will not be
reused
28. Remove headlight washer circuit if fitted
and retain for reuse.
29. Remove fog light loom if fitted for reuse
30. Place bumper face up on a bench or
similar so there is sufficient access for the
cutting operation
31. Using a jigsaw, carefully cut along the
edge of the masking tape.
32. Remove burrs from the cut edge of the
bumper, then set aside on the soft non
abrasive surface.
Cutting edge
Warning: Cutting
operations can result in
flying debris, safety glasses
should be worn. Work
safely; keep fingers clear of
cutting blade.
Cutting line