ARB 3915040 - Manual (Page 9)

Last Rev Date: 28 OCTOBER 2008 Page 9 of 22 Fitting instructions# 3781218
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
REMOVAL OF BUMPER
19. Release top of grille. It is retained by 2 x
push in spring clips, located at the outer
top sections below the bolt position.
Hint: You can use a small flat blade
screwdriver to aid in pushing in spring.
20. Pull outer returns of bumper outwards
and out of retaining clips.
21. If required push bumper down
immediately below headlamp to gain
access with a small flat blade screwdriver
and release holding tab.
NOTE: Take care not to damage painted
edge of bumper
22. Remove plastic plugs securing upper
bumper tabs to cross member.
23. If headlight washer system is fitted
disconnect the main line from the vehicle
to the bumper circuit and clamp/crimp it to
prevent washer fluid from leaking out
24. If factory fog lights are fitted, disconnect
the fog light harness from the vehicle by
opening the white flip over clip on the
connector and releasing the loom plug..