ARB 3915040 - Manual (Page 15)

Last Rev Date: 28 OCTOBER 2008 Page 15 of 22 Fitting instructions# 3781218
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION OF BULL BAR
59. Fit 4 x M6 cage nuts to bottom inside
face of lower pan in square holes as
shown.
Hint: A small flat blade screwdriver may help to
press nut cage flanges into hole.
60. If parking sensors are to be fitted, mark
out the hole positions, located in the
middle of the large corner radius of the
wings and 90mm down from the top face.
(Similar position to original bumper)
Hint: Use two rules across flat faces to find
mid point of radius
61. Once Dia 22 (7/8”) hole is drilled and
fully deburred, check that the hole size is
actually Dia 22.0 – 22.8mm, better if on
larger side. Trial fit sleeve and sensor.
62. Once checked use some fast drying
primer paint to seal bare edges.
IF FITTING FRAME AND BUFFERS
63. If fitting centre frame, loose fit the pair of
buffers with holes P#3163017R&L by
sliding up onto frame, noting that the
buffers are handed.
64. Mount frame and secure with 2 sets of
M10 x 40 cap screws and washers per
side as shown, noting that the frame leans
rearwards once on vehicle
65. Slide buffers down over frame until they
sit correctly onto bull bar and tube profile.
66. Fasten buffers with 6 x M6 flange nuts
per buffer once buffers are carefully
pushed home against the profile of the
bull bar and centralised over tube, be
careful not to over tighten the flange nuts
as damage to buffer can result.
Warning: Cutting operations
can result in flying debris, safety
glasses should be worn.
Sensors fit on
these outer
corners, 90mm
down from top
face
Hole saw Dia 22.0 (7/8”)