ARB 3915020 - Manual (Page 3)

05/01/04 Page 3 of 9 3783077
ASSEMBLY SEQUENCE FOR WINCH BUMPER.
1. 1. Remove the bumper bar from the vehicle.
2. Position the lower buffer on the winch bumper
and assemble using the M6 flange nuts. (do not
overtighten)
2. 3. Insert the side buffers through the holes and fix
using the M6 flange nuts. (do not overtighten)
5.
4. Glue the light surrounds to the bar using a
silicone based rubber adhesive. Run the bead
along the cavity on the rear side of the part.
Position the surround to align the inside edge
with the buffer and concentric to the light.
5. Wipe off any adhesive on the front face of the
bar. Allow adhesive to cure before continuing.
6. If fitting optional fog lights, do so at this
stage.