ARB 3915020 - Manual (Page 4)

05/01/04 Page 4 of 9 3783077
7.
7. Push the top chrome tube through the hole in
the buffer and fasten using the M12 x 40mm
bolts, washers and spring washers.
8.
8. Mount the Impact Absorber brackets to each
side of the chassis using original fasteners.
9. Fit flat washer 35 x 12 x 2.5mm to side hole of
bracket and fasten.
9. (If fitting the winch.)
10. To place the winch clutch handle in a convenient
location the winch gearbox must be rotated 2
hole spacings, 72 degrees, in an clockwise
direction when viewed from the gearbox end.
Place the winch on its end and remove all
gearbox bolts. Gently raise the gearbox just
enough to rotate it. Do not completely remove
the gearbox and avoid damaging the gasket.
Refit all bolts and tighten.
NOTE: Take care not to lift the assembly more
than a couple of millimeters while rotating to the
desired position to avoid unmeshing the gears.