ARB 3915020 - Manual (Page 5)

05/01/04 Page 5 of 9 3783077
10.
11. By undoing the screws on the side of the control
box, remove the top cover and replace the three
short leads with the longer ones supplied in the
fitting kit.
12. Position the control box bracket, then the lead
insulator bracket to the back of the control box.
13. Ensuring the leads are neatly on top of the bkt
place the cover bkt on and fasten with the
control box nuts and the M6 x 16mm bolt and
flange nut.
11.
14. Fasten control box assembly to the bar using the
M6 x 16mm bolts and flange nuts.
12.
15. Install the winch and roller fairlead using bolts,
nuts and spring washers supplied by Warn, and
the 25 x 11.5 x 1.6mm flat washers supplied in
the bolt kit. Refer to Warn installation
instructions for correct procedure. Adjust winch
in slots until the winch is centralised in the bull
bar.
16. Connect Control box leads to winch. Refer to the
Warn winch handbook for additional information.