ARB 3915020 - Manual (Page 6)

05/01/04 Page 6 of 9 3783077
13. (If not fitting winch)
17. Wrap rubber extrusion around the winch cover
and trim excess.
18. Place spacer washers over the winch cover
fixing holes, located on the top face of the winch
bumper.
19. Place the winch cover on top of the winch
bumper inline with the mount holes.
Bolt together using the M6 button head stainless
steel screws and M6 nuts.
14.
20. Using sharp scissors or a cutting blade , cut the
plastic inner guard as per line shown in the
photo.
15.
With winch
Without winch
(If fitting with winch.)
21. Peel off one side of the double sided tape and
adhere to the top rear side of the number plate.
Note: Clean the adhering surfaces before
applying tape with an alcohol solvent.
22. Peel off the other side of the tape and bolt to the
winch bumper with the M6 X 16mm bolts and
M6 flange nuts through the lower holes of the
number plate.
23. Press firmly to the top of the number plate so the
tape can properly adhere.
(If not fitting with winch.)Bolt the number plate
through the top holes using M6 X 16mm bolts
and M6 flange nuts. If desired the double sided
tape can be used down the sides of the number
plate.