ARB 3915020 User Manual
Page 8
05/01/04
Page 8 of 9
3783077
19.
28. Using a sharp knife cut the excess rubber in line
with the inside end of the wing. Only cut the
inside excess, the other end will be cut when the
winch bumper is fitted.
20.
29. With the aid of another person carefully place
the bar on the mounting brackets.
30. Horizontally and vertically align the bar to the
body and fasten using the six M12 x 40mm
bolts, large washers and M12 spring washers.
Tighten all bolts so as the large washer deforms
inside the cutout.
31. Drill out the lower pin bolt hole on each side with
a 8mm or 5/16” drill bit.
32. Fasten with 8mm x 16mm bolts and flange nuts.
21.
33. There are two 16 dia holes located on the top
face of the bar. If no CB aerials are fitted the
holes can be covered with the plastic plugs
provided in the fitting kit.