SkyTrak 3606 Service Manual - Manual (Page 101)

Cab, Covers and Mirrors
4-15
6. From the outside rear of the cab (Fig. 4–18), remove
the four button-head capscrews and plastic washers
securing the outer rear panel to the cab. Remove the
outer rear panel.
Figure 4–18. Remove the button-head capscrews and
plastic washers securing the outer rear panel to the cab.
7. From the outside rear of the cab, remove the three
hex-head capscrews, lockwashers and flat washers
securing the rear tool bin to the cab (Fig. 4–19). Save
the fasteners for reinstallation later.
Figure 4–19. R emove the three hex-head capscrews,
lockwashers and flat washers
securing the rear tool bin to the cab .
8. Inside the cab, raise the glove box armrest. Inside the
glove box (Fig. 4–20), remove the three capscrews,
lockwashers and flat washers securing the rear tool
bin to the right side of the cab, to the right side cab
wall, and to the front dash. Slide the seat completely
forward and remove the rear tool bin. Save the
fasteners for reinstallation later.
Figure 4–20. Remove the fasteners
from inside the glove box.
9. Use a one-inch (25mm) wooden block (Fig. 4–21) or
other suitable device to raise and hold the front dash,
allowing access to the nuts on the underside of the
joystick. Remove the three long nuts, lockwashers
and flat washers from the underside of the joystick.
Remove the three flange-head capscrews. Save the
fasteners for reinstallation later.
Figure 4–21. Raise the dash with a wooden block and
remove the fasteners securing the joystick.
10. Reach through the logic panel opening and position
the joystick wires as shown in Fig. 4–22 on the next
page. Raise the joystick enough to expose and allow
access to the hydraulic hose fittings connected to the
joystick control valve on the underside of the joystick.
Note: As required, remove tie wraps securing the joy-
stick hydraulic hoses together beneath the vehicle frame.
Removing the tie wraps will allow the hoses to be pulled
further out of the joystick opening in the console.
SS1230
Cab
Button-head
Capscrew
Plastic Washer
Outer Rear
Panel
Cab
Rear Tool
Bin
Flat Washer
Capscrew
Lockwasher
SS1250
SS1240
Capscrews,
Lockwashers
and Flat Washers
Joystick
Front Dash
Wooden Block
"Long" Nut
Flange-head
Capscrew
Flat Washer
Lockwasher
SS1260
Model 3606 • Origin 10/99